So I'm having a bit of a problem with a T97 NSR. The ejector appears to be pinned in or bent slightly low, such that it's causing the bolt to ride low and putting a lot of wear on the upper surface of the left bolt rail. The rifle thus far continues to function fine, but I'm worried about the increased resistance from the bolt rubbing the bottom of the ejector and top of the bolt rail in its slot causing it to fail to go into battery, or the wear eventually causing breakage of either the rail, ejector, or bolt.
Any ideas on how to address this? Can the ejector be adjusted? I'm a little leery of attempting to hammer/bend it into its correct position, but I'm not sure if there are any other options.
Any ideas on how to address this? Can the ejector be adjusted? I'm a little leery of attempting to hammer/bend it into its correct position, but I'm not sure if there are any other options.
Last edited:
