Tactical Innovations 10-22 mag

chrisco

chrisco

CGN frequent flyer
Rating - 99.5%
182   1   0
Location
Downstream of the Falls -- Ontario
My Tactical Innovations 10-22 mag is having feeding problems. Any advice form anyone who has one of these magazines? The problem seems to be that as the front of the round begins to chamber itself, the back end does not advance upward fast enough and the rounds end up jamming in an angled postion.
 
This happens sometimes when either the gun, the mags, or both get too dirty.

If that doesnt fix it then you are likely too low. Youve got to keep playing with the positioning of the screws until it works right. Its a bit of work, but once you are there, they are the best mags money can buy.

Make sure they dont fit too tight in the gun either. There should be a little wobble.
 
Yeah I had the same issue, means that it is feeding too low and probably a slight flaw is catching on the chamber. Try lowering the front screws a bit and raising the back ones.
 
Mine don't feed the ammo. It sits below the feed lips. The mags are new and the spring doesn't seem to have enough tension or something.
 
Ugh I had the same problem, I have no idea how I fixed it but I eventually did. That's the only downside to Tactical Inc magazines, you need patience fitting them to your rifle. But once you get through that, it's a blast.
 
Mine was new and acted that way until I put a hundred rounds through it, now it's great, way better than plastic butler creek mags.
 
Have you taken the magazine apart? On one of mine, there was a plastic "bure" on the back of the follower that was causing some drag... 2 seconds with a pocket knife took care of the issue!

Also, the magazine might not work on some older 10/22 (At least they don't on my late 60's gun... even with the screws all the way in, the bolt won't pick up a round) but they work great on the recent production gun.
 
You must log in or register to reply here.
Back
Top Bottom