Tight LAR15 mag after TacPul?

[Abey0beyCeezy]

Bought 5 lar's. Real easy job. -replace floors with Tacpul
slide some Tacpul's on floor plate-
prior to installing Tacs, LARs were easily ejected from Tavor mag well.
MORE than drop free, they were ejected...
now have 3 Lars with enough snugness to not drop out without assistance.
Due care was used on all mags, same process , etc.
It may be that with the weight of 10 shells the ease of ejection will return,

just looking for any similar experiences and see if there is something easy I can do to get my nice ejection of mag back.
maybe someone else has seen this?
thanks- A0C

 

[JaysonCraig]

i am pretty sure the thickness of the plate originally, is the same as on the tac pull. This should not be your problem imo.

Maybe the spring is binding inside? Anyway, it doesn't matter if you have 10 rounds in, and it ejects well. 99% of the time you will be ejecting empty mags.

You should take the tac pull off and re install it. and then if the mag is still tight, take the tac out and compare it to one thats ejecting good. compare it to a factory plate. put the factory plate back in and see how that specific mag ejects. Do all that and you will have either eliminated/proved both the plate and the spring. All thats left is a mag defect, start comparing those. Maybe one got bent?? who knows.

I use 4 of them with tac pulls in my AR, so it may be diff.

 

[jcuffe6240]

I also have one that is tight after I install a C-product tact pull. It is actually tigh even with no rounds in the magazine at all. I use them on my Norc M4. But I will try them without the tact pulls on them tonight and see.