TNW Suomi Trigger Pull

[diabeticfreak]

I searched the forums recently and saw there was a post from a few years ago about decreasing the weight of the trigger pull. I want to use mine more often, but I can never really justify bringing it out because of the crazy trigger pull weight. In the couple of years since that last post was made, has anyone figured out any other ways to lighten the trigger besides sanding it down? And if not, lets turn this into a Suomi picture thread.

 

[Deathrawt]

I read somewhere on a different forum that you could wrap thin wire around one of the pins in the trigger group and that would lighten the pull but could cause it to shoot doubles if the wire was too thick
I can’t remember which pin you were supposed to wrap and I never tried it so not sure if it even works

 

[diabeticfreak]

I read somewhere on a different forum that you could wrap thin wire around one of the pins in the trigger group and that would lighten the pull but could cause it to shoot doubles if the wire was too thick
I can’t remember which pin you were supposed to wrap and I never tried it so not sure if it even works

I have heard that too, but I've never tried it either. I may need to be on the lookout for some wire if no one else has any ideas.

 

[quinnbrian]

That was the reason I sold mine.... sludge hammer of a trigger! Almost cut your finger pulling back on it.

 

[Torandir]

The wire trick does work, I have done it in mine, but yes you do have to be careful about going too thick or it won't reset the trigger. the pin circled here is the one that needs to be wrapped. Be warned the trigger group is very finnicky to reassembly.

https://photos.app.goo.gl/7zKrDC2aqcgKSPsk8

 

[howard2]

It appeared to me that in the TNW build process, the internal parts all seemed to have a coating. I buffed the internals, no metal removed. Trigger pull was far better after this polishing.