Torque Question

[duke1]

I want to buy a Torque wrench or Torque screw driver for installing screws on gun actions and on bases and rings. I would like to know what would be an adequate range of Torque in in-lb for such applications.

If by any chance you know what the specs are for each of these applications, it would be greatly appreciated.

I used to know what it is for the typical rings and bases but can't remember where I had gotten the info from and don't remember the numbers (might have been in the 20 in-lb range for the rings and in the 60 in-lb for the bases??.

Thanks,

Duke1

 

[RePete]

You should get 10 - 150 in lbs.

And go 1/4" drive.

RePete.