TPS/NF scope base; MUSGRAVE TR?

[thunderflash]

Anyone know if Nightforce or Tactical Prec. Sys. make a scope base to fit a Musgrave Target Rifle ?? If so part #'s would be appreciated !

 

[tiriaq]

My Musgrave is not drilled and tapped for a scope. Maybe some were, or have been since leaving the factory. Countour is constant end, to end. Maybe something made for a late Savage with round rear bridge might work.

 

[peterdobson]

Warner Tool has M1913 and Weaver sloped bases and will post response to my inquiry on this.

 

[Ian Robertson]

Most Musgraves are not drilled for scopes. They normally have two holes at the rear which was for the M&S irons. I would think that if yours is it was done after market and would be an unknown spacing.

 

[thunderflash]

You are right,-- On the two I have there are no holes that have been drilled & tapped for scopes ,( also heard they may be a ##### to drill?) thinking of mounting a scope & wondering what make of picatinny mount would best mate to the reciever.--- i suppose i could always "bed"one if all else fails .

 

[Ganderite]

My actions are untapped. Ya, I heard they are hard to drill.

 

[Ian Robertson]

I have put Barnard rails on several of them. Barnard rails are 17 minute tilt and steel or aluminum. Musgraves seem to drill fine but I don't bugger about with anything but a new drill on something like this. I make them m4 so the screws suit the rail.