trigger job on CZ-858

[homer76]

For anyone who owns a CZ-858: has anyone done any work to improve the trigger and if so do are they willing to share what they did and what the results were?

 

[venom_bullet]

that is a great question. I second that.

 

[pac_man]

I was wondering the same thing. After shooting AR's for many years I find the CZ's trigger horrible and want to fix it.

 

[venom_bullet]

well from the time span that Homer put up this thread. It looks like no one has an answer yet

 

[John Marshall]

I polished the contact surfaces with a fine grit stone, I was careful not to remove to much material but just improve the finish.. Helped quit a bit.

 

[obiwanbonjovi]

do not reduce sear spring pressure or overtravel without first modifying disconnector timing to eliminate gremlin. REducing sear spring or overtravel will cause the gremlin to be more prevalent.

 

[venom_bullet]

do not reduce sear spring pressure or overtravel without first modifying disconnector timing to eliminate gremlin. REducing sear spring or overtravel will cause the gremlin to be more prevalent.

very good point