Trim-Chamfer-Deburr

L

lacesout

Regular
Rating - 100%
3   0   0
Location
Saskatchewan
I'm using the lee case trimmer with a drill to case trim... Also have a hornady case prep trio to chamfer and deburr. I would like an all in one solution! It would be really nice to use a Dillon's Rapid Trim 1200B Case Trimmer right on the press with a vacuum! Does anyone have experience with the rapid trim? Does it also chamfer and deburr? The RCBS with a 3-way cutter seems like a good option. The forester case trimmer with its version of a 3-way cutter looks even better. Anyone have anything to say about the Lock-N-Load® Power Case Prep Center?

Im reloading .308 for now.
All feedback is appreciated!!!
Thank you!

I made a press fit ring to fit over the shell holder so i can hand tighten it easier. Also made the ball handle. Both are aluminum! :)
20120820225045.jpg
 
Currently doing most of my trimming with the Lee system. Lots of 223, 308 and 30-06.

Lee Ball grip cutter and a Lee Zip trim. I trim, then chamfer and debur with the Lee or RCBS tool. Then usually debur flasholes on new brass with Lyman tool while still on zip trim. I also chuck tools like the debur and primer pocket uniformer in a drill press.

I have been thinking about the Giraud trimmer set up for these three high volume calibres as well but haven't spent the money on one yet.
 
I got the rcbs three way cutter on my lyman uni trimmer. Sooo much nicer than before. Mind u I had to make a new shaft to fit the smaller rcbs threads.
 
You must log in or register to reply here.
Back
Top Bottom