Trimmer options

Sniffer

Sniffer

CGN Ultra frequent flyer
Super GunNutz
Rating - 100%
44   0   0
Location
Okanagan
I`m getting prepped up to trim brass

I will be reloading 223 & 6.5 Creedmoor. I want something that makes this process as easy/fast as possible and as far as i can see only the Giraud trims & chamfers the inside and outside at the same time so one pass leaves the cartridge good to go

As I have a Dillon 650 I considered a RT1200 or RT1500 which fit onto the press but I decided against this for 2 reasons, it doesn't chamfer inside/outside and I don't plan to trim 6.5 Creedmoor on my progressive (got a Forster single stage on its way)

Are there any other products on the markets I should be looking at?
 
Gracey trimmer. Trims to length, chamfers inside and out and take about 2-3 seconds per case. Work like an electric pencil sharpener.
 
I have the lee quick trim with a drill. Works fine. Trims, chamfers inside and out in one pass. They call it the DELUXE POWER QUICK TRIM. Not expensive but you need a die (about 14$ each) for each calibre. Worth trying unless you are anti-Lee for some reason.

http://leeprecision.com/deluxe-power-quick-trim.html

I think I bought mine at x-reload but not 100% sure.

I also have a lyman E-ZEE Trim, which works ok, also with a drill, but doesn't chamfer the inside or outside. Comes with a bunch of pilots for a bunch of calibres and new ones are cheap at around 4$.

I much prefer the Lee over the lyman. If you want to make large volume make sure you have something motorized cause trimming by hand gets long and boring really fast.
 
You must log in or register to reply here.
Back
Top Bottom