Hi folks. Question here for all that have drunk the CZ kool aid and use a NEA upper with the above mentioned optics. I have a bit of a issue with mounting a lense cover on these optics because I run them all the way forward on the rail. There is very little room to get the lens cover between the bottom of the lens and the handguard. Anyone got any ideas of a supper thin lens cover to use. Thanks
trs-25 & Sparc lens covers?
- Thread starter millwright
- Start date
What you could do is make one out of clear pop bottle plastic. Trace the tube onto a flat piece of plastic. Cut the circle out about a centimetre or so in diameter wider. Cut a series of triangular relief cuts from the edge to the line you traced. Bend the tabs over and wrap duct or hockey tape to hold the tabs against the tube and there you go. If you can stand the ghetto look you have a lens cover that looks like a bottle cap. Not flip up or anything but it should work and be super thin
