With all of the dismantling and painting of my USGI stock, I went to reassemble it tonight and I think I am missing something. While the bottom bolt threads into the sling swivel, is the top bolt supposed to thread into a nut inserted into the hole? It has been some time since I took it apart and I cannot remember.
USGI Butt Stock plate??
- Thread starter berger
- Start date
DOH!! I guess I could do that too! Thanks..
berger:
Home Depot proposition... It's a number 8 x 32 IIRC, or something like that. Then again, the buttplate folds over the screw, so anything like a #8 x 32 x 2.0" long will do the trick.
Cheers,
Barney
Home Depot proposition... It's a number 8 x 32 IIRC, or something like that. Then again, the buttplate folds over the screw, so anything like a #8 x 32 x 2.0" long will do the trick.
Cheers,
Barney
I have the bolts and nuts in SS. the large square nuts with bolts aren't as easy to find as you would think. I also have the forward cap screws and nuts for the forward sling swivel,also in SS. Its the same set up that the NRA shooters use. I had to get them from the US. they are not metric....doesn't matter.
mikebaker1129
CGN Regular
- Location
- TEXAS, U.S.A
The size is 10-32 on the square nut. Not sure if you have them in Canada , but a good hardware store should have these nuts.
If not send me a PM and I will send you a couple !
Mike
If not send me a PM and I will send you a couple !
Mike
