Uzkon T2 Disassembly???

[greywolf67nt]

Has anyone found any videos online showing the how to on this?
Is it equivalent to anything else that there IS a video for?
I need to get the firing pin out so it can be used in the CFSC course.

 

[greywolf67nt]

Well that was easy enough.
No videos but only $150 shotgun so what was I out?
2 Phillips screws out of butt pad.
1 x 1/2" bolt takes stock off.
2 small pins along the bottom of the receiver and trigger group comes out. It does have the spring for the action release in the front of it but not much pressure.
1 small pin 3/4 of the way up the receiver tap it out and TADA firing pin is out.

Reassembly is just that in reverse.
When putting the trigger group in I got a punch a little smaller than the pins and got one hole lined up (you are holding slight spring pressure from the action release). got first pin in and then pulled punch and inserted second pin.
Butt stock back on.
Butt plate back on.
DONE!

I think the whole procedure took MAYBE 30 minutes and I no exactly SQUAT about break actions

Oh I did take the barrel off figuring it would be necessary. It WASN'T