Vihtavouri lovers

Whats the Viht equivalent for 4831SC for a 284 Shehane?

Never used Viht as I could never justify spending the extra money on it over Hodgdon products.
 
This is good to know, I have a kilo on the way for my 284 winchester and 140 BT's.
Don't forget, all guns are different and yours may not like VV-160. However, here is my load and the rifle is not a bench target rifle, but a hunting rifle. Good luck and happy load development!

 
I use N340 for 9mm. I find its very snappy and creates a pretty consistant load, as well tightened my groups up quite a bit. Even in faster paced shot groups from 15 yards.
 
I have a very accurate 270 Winchester load, using the 140 grain NAB and VV N165

3k velocity, plus sub moa consistently out of a factory Sporter with a 24" tube.

That's about as good as it gets.

Regards, Dave.
 
They are amazing powders as far as accuracy and consistency from lot to lot. Hard to beat Vhit powder in the 9mm when loading heavy bullets for velocity.
 
since i've started reloading i've used and still use vitahuori powders exclusively. VV340 ,VV320,3N37 for .40 and 9mm. very clean and consistant jug to jug ,not temp sensitive and generally the powder bar meters well with vit powders.

can't wait to get a hand on VV310 for my 9's . very fast i know but i found a crazy flat shooting load 22 alike wiith that one.
 
since i've started reloading i've used and still use vitahuori powders exclusively. VV340 ,VV320,3N37 for .40 and 9mm. very clean and consistant jug to jug ,not temp sensitive and generally the powder bar meters well with vit powders.

can't wait to get a hand on VV310 for my 9's . very fast i know but i found a crazy flat shooting load 22 alike wiith that one.
N340 4.9g with 124g jhp or fmj reg small pistol primer.
 
Last edited:
Back
Top Bottom