Vihtavuori powders

Cant say for 38 special, but I used n350 extensively in 357 mag for mid power loads. I use it now in my 44 mag for light mag power loads. It meters well, burns clean, is accurate and very very consistent.
My favorite load for the 44 mag gives single digit velocity spreads.
 
i use vv320...vv340...3N37...3n38... VV350...vv 330...for my different pistol calibers.what i like is that,this powder burns super clean,meter great in my XL650 , and is 100% consistent from batch to batch.i load 9mm ,45acp and 40 S&W with all the powders mentioned.the 350 is very,very fast for 9mm,not exactly recommended,it is more dedicated to magnum calibers,but i found a super dooper load for one of my steel 9mm.

some will tell you that it doesn't worth it,too expensive and blahblahblah,but i like the no smoke and clean burning factor ;i use Vihtavuori powders exclusively.
 
I use them in my rifle loads: N140, N550, N160. They are not as expensive compared to Hodgdon or IMR now as they used to be previously.
 
Thanks for responce, folks!
I tried today, 50 round 38spl, 5.5gr N350, S&B primers.
Cleaning took me half time than usual, so it for sure cleaner than anything I tried before.
Accuracy - yes! 25 yards benchrest 1 inch group.

Found some unbarned powder, but I think it could be solved with lighter chardge or different primer.

Recoil nice, sharp and short, something like CFE pistol.
 
You must log in or register to reply here.
Back
Top Bottom