LuckyCookie
New member
I recently bought a vz58 and I decided to do a detail strip of the bolt (it took a lot of work and time). I followed the youtube video to detail strip the bolt and put it back together following these steps. 1. Put the firing pin back into the bolt, made sure that the firing pin was aligned with the extractor. (straight in the bolt). 2. I put the spring, extractor stay in the bolt and put the extractor back in and pushed it in creating an angle. 3. I used the sharp tool again and pushed the spring to try to align the extractor with the bolt. When I write this out, everything sounds so easy and everything is okay. It took a while to disassemble and reassemble the bolt group. Is there an easier way of detail stripping the bolt especially the extractor and the extractor spring part?
Last edited:
