VZ58 or CZ858 with a Ace ARFX stock and a Stormwerkz straight inline adapter question

Ebola

Ebola

CGN Ultra frequent flyer
Rating - 100%
21   0   0
Location
Outside Your Window Looking In
Figure I will ask my question here as I have seen a few pictures in the past posted here of members with the exact same set up. Im debating on putting a folding ARFX Ace stock with a straight inline Stormwerkz adapter on it. Can anyone speak to the cheek weld for the iron sights? Im still planning on using them. Its hard to tell if I will be able to comfortably do so. I know the height on the adapter is adjustable. I just don't know if the stock sits low enough for a proper comfortable weld. Thanks for any info provided.
 
I have one on an angle adapter and love it.it might work out,only problem if you have big hands and go low on the adapter,the hinge rubs on the top of your hand and can make an uncomfy grip.
 
You can use the irons IF the stock is set on the lowest setting. If not then your squishing your face against the stock just to get a sight picture
 
bfiles said:
You can use the irons IF the stock is set on the lowest setting. If not then your squishing your face against the stock just to get a sight picture
Click to expand...


Now I know which rifle you was referring to Ebola. I agree with bfiles. The stock needs to be set low. I found when I did that the adapter rubbed on my hand. It kinda ruins the lines of the rifle too if you care about how it looks. The factory angle adapter would get you low enough without dropping the adapter way down.
That's why I run a red dot on a BC tactical upper handguard on that rifle. I do really like the AKFX folding stock.
 
You must log in or register to reply here.
Back
Top Bottom