While it's a great stock, it does have a sharp edge at the top-rear part of the pistol grip that can be hard on your dominant hand.
On a good note, it's stupid easy to round off. You can either hand-sand it or use a Dremel (be careful not to damage the receiver finish and run it on the lowest speed possible to avoid melting the plastic). You should still finish it off with a bit of hand-sanding. You can probably also use heat but Dremel was easy enough.
On a good note, it's stupid easy to round off. You can either hand-sand it or use a Dremel (be careful not to damage the receiver finish and run it on the lowest speed possible to avoid melting the plastic). You should still finish it off with a bit of hand-sanding. You can probably also use heat but Dremel was easy enough.
