What do I need? (to reload 7mm)

P

pilot_dc

Regular
Rating - 100%
60   0   0
Location
Ontario
Ok, I've looked through manuals and I'm still confused as to what I need and what is just "nice to have" and what duplicated the functions of other pieces.. I have a little experience reloading 12Gauge and 45ACP but this seems to be a whole different experience.

I'm looking mainly to save $$ but eventually I will be loading for accuracy.

I have a single stage press and a powder scale. I'm missing dies.

I was told a neck resize only die, and a case trimmer would be a good start.

So what else would be a worthwhile BEGINNER investment..

Thanks all!
 
Get a complete die set, for yor caliber I like the hornady or lee delux sets (price wise lee is the best)
you'll need some case lube (haven't tried KY-jelly but should work,lol)
Digital calipers (25$ @ crappy tire) and campher/deburing tool.
and some device for insering the primers.
That's all i can think of right now
 
I would go with RCBS dies as they are threaded with no collets to slip,and if you do have a problem,RCBS has great customer service.You will also need a matching shellholder.You need a primer pocket cleaner,as well as inside and outside chamfering tools.Neck sizing will generally provide slightly better accuracy,but you should full length resize hunting rounds.
 
If you neck size,the tolerances will be extremely close,so a tiny bit of dirt or grit can cause problems chambering a round.Any problems chambering a round could result in a lost shot opportunity.In fact,depending on the chamber and die dimensions,it sometimes takes a good push on the bolt to chamber any neck sized rounds.This is not a good situation to have under hunting conditions.
 
Also, if you are buying bulk brass, you should full-length size it the first time around. After that, if they are going to be shot in the same gun, you can get away with neck-sizing only.

Case lube and a pad. Both are cheap and will last a long time. There's a recipe out there to make the lube but I'd just buy it. Also, a rack to hold your shells, inexpensive as well.

Lee makes a great inexpensive case trimmer.
 
If you only neck size, make sure you run each round though your action. That way you can be mostly sure that you should not have a problem, unless as mentioned, you have dirt. But dirt could also hinder a full length sized round.

You might want to invest in a manual powder trickler. Only $15 or so. It will help you get those measurements close. Also some brushes to clean at least the necks of your shells.
 
You must log in or register to reply here.
Back
Top Bottom