Where do get Glock Sight Puller?
- Thread starter GunGuy34
- Start date
- Location
- Fort St John B.C.
word of caution, to reove the factory sights get the glock factory pusher, if your installing trijicon your going to need either the trijicon tool or the MGW one cause trijicons are tight, if you installing the factory glock night sights the glock tool will get them on.... but the caution is still there that it may not as well.
when using the mgw or trijicon sight tool to remove the rear Factory plastic sight they usually ruin it, if you don't mind that then don't worry...
to buy the Trijicon Factory tool which is around $100 phone police ordnance in ontario, they also sell nightsights and the factory glock tools as well.
when using the mgw or trijicon sight tool to remove the rear Factory plastic sight they usually ruin it, if you don't mind that then don't worry...
to buy the Trijicon Factory tool which is around $100 phone police ordnance in ontario, they also sell nightsights and the factory glock tools as well.
Glock factory night sights are Trijicon sights. At least so i thought. Ive bought guns new with those installed from the manufacturer.
- Location
- Fort St John B.C.
glock has thier own brand of night sight, it actually is about twice as wide on the rear sighting plane as the trijicon ones, the trijicons are the same size as the dovetail width with just a tiny shelf, where as the glock one from questar for example sit farther back on the slide by about an additional dovetail width.
the glock sights supposedly have a better warrenty then trijicon as well...
notice they have the glock logo on top
trijicons do not
Made my own block from old plastic cutting board, cut to width of the rear sight. Mind you it's the cheap plastic factory so easy to knock out. Used same to knock in FO rear. Not sure about banging out Trijicons.
For front belt sander flatten a 3/16" long socket in seconds, couple more to add bevel, works great.
For front belt sander flatten a 3/16" long socket in seconds, couple more to add bevel, works great.
I just ordered the one from Glockmeister. Comes with front sight tool as well. Orders night sights with it. As well as another set in 6.9mm for the G21 Gen 4 im going to get in the future when more show up in Canada.
Glock site installation tools..... Google is your friend:
http://www.glockmeister.com/Glockmeister-Sight-Tool-for-All-Glock-Models/productinfo/GMST/
--------------
NAA.
Ya I didnt think they shipped to Canada, my bad. Ill be ordering other stuff from them if my current order goes through without any problems.
