Where to find lower handguard pin for czh2003, cz858 ?

[sunjeep24]

Lost pin some time ago. My csh2003 Fab defense handguard still fits tight but does have some play room. Stock beaver barf is loose. Does anyone know where to get one or sell there's?

Anyone know a comparable bolt etc that will work instead

 

[svt1940]

I am sure you can find a roll pin at any hardware store/autoparts, that would do the job.

 

[Horilka]

Certain spring roll pins will do the job even better than original.

 

[svt1940]

I just checked on mine, the original pin was kinda loose so i took a 5/32 roll pin, cut to proper lenght and installed. Now wont come loose again

 

[VanIsleCam]

Yeah - so 5/32 is the correct width? I wonder as I see handguards etc. on EE but rarely are the pins with the pieces.........

 

[svt1940]

Yeah - so 5/32 is the correct width? I wonder as I see handguards etc. on EE but rarely are the pins with the pieces.........

Yes, 5/32 is the correct diameter,just need to cut the roll pin the proper lenght and you are good to go. The original pin is installed and flared in place at both end but once removed,the pin will come loose. A roll pin is the perfect replacement,easy to find at low cost.

 

[agentcq]

Yes - roll pin is the way to go. The military parts chests have extra hand guards but no roll pins - this probably explains why you see furniture but no pins in the EE.

 

[VanIsleCam]

Thank you very much guys.