Which grip for XCR?

kykamo

kykamo

Regular
Rating - 100%
20   0   0
Location
St Paul, AB
I want to replace the A2 grip on my XCR. I know I want to try the "steep" angled ones, but I suffer from stubby index fingers and don't want the new grip to increase the trigger pull to much or else I may not be able to reach the mag or bolt release. I can reach them fine now with the A2 grip, but I might only be able to give up a quarter inch max. So which grip should I get?

Also worried if there are any grips that just don't work well with the XCR??

I was looking at the Magpul K2 (or K2+) or the bcm mod 0 or mod 3

I'm worried the beaver tail on the K2 and mod 3 will increase the trigger reach too far and the mod 0 is the only "steep" grip without a beaver tail so I should just get that? But I think the K2 and mod 3 may be more comfy and have better stippling?.

What do you guys think? Do these grips increase the trigger reach too much for me? Anyone with experience with the mod 0 vs the others? Is the mod 0 just as comfy?

Thanks for the help
 
Personally, I like the Magpul MOE+ with rubberized grip and storage compartment (I find it a slimmer grip than the Magpul MIAD with interchangeable back straps). The BCM grips are also really good, so I honestly don't think you can go wrong with any of the choices you mentioned. The only grip I've ever found to be a tad steep was on the HK MR223.
 
I'm a fan of the K2+ with the reduced grip angle, but it has a beaver tail so may make for a longer pull, the Troy battle axe control grip has the reduced angle without the beaver tail and may be a good option, I have a bum wrist and the angle doesn't bother it as much as a standard grip.
 
You must log in or register to reply here.
Back
Top Bottom