Which revolver speed loaders?

[RePete]

Not IDPA legal.

 

[Dexter Morgan]

Not IDPA legal.

Care to elaborate?

 

[RePete]

Does not cover the body of the speedloader. It's the one I used when I shot PPC.

The info is in section 8 of the rulebook.

 

[StoneHorse]

Anyone know where I can find these in Canada?
Kydex speedloader pouches.

Update: Manufacture does not ship outside the US.

 

[CV32]

Read carefully.

8.6.3 Speed Loader and Moon Clip Carrier Rules
A. Be suitable for concealed carry and all day continuous wear.
B. Speed loader carriers must either be of open top configuration that covers at least 45% of the diameter and 100% of the cartridge height when viewed from the front, and must retain the speed loader by tension or retain the speed loader with a snap or Velcro closure. Side cuts are permitted for thumb and index finger access only.

 

[Canuck44]

Do they cover 100% of the cartridge when viewed from the front? From the pictures you provided they don't seem to. I would assume you only have two speedloaders in the pouch in any event or have all three on the weak side.

I will throw a vote in for Jetloader speedloaders which in my view are a bit easier to grasp and index with the exposed spring. Very popular up here.

To the OP make sure your holster does not hold the revolver out from your body more than 3/4". If you are thin or without the experienced lower bulge this rule can play havoc with revolver holsters. It is a rule that is very much body dependent.

Take Care

Bob

 

[StoneHorse]

To the OP make sure your holster does not hold the revolver out from your body more than 3/4". If you are thin or without the experienced lower bulge this rule can play havoc with revolver holsters. It is a rule that is very much body dependent.

Take Care

Bob

I have ordered a concealment holster from Solely Canadian so I'm assuming the revolver will be tight to the belt. My 'spare tire' is minimal but I don't think there will be an issue.

 

[Canuck44]

I have ordered a concealment holster from Solely Canadian so I'm assuming the revolver will be tight to the belt. My 'spare tire' is minimal but I don't think there will be an issue.

All depends on what attachment he uses. Let us know. The test FYI, is a 3/4" dowel placed between the holster and your body. Any part of the gun that the dowel hits gives you a thumbs up.

Take Care

Bob

 

[rekx]

Can anyone tell me about the SL Variant speed loaders? I just stumbled on 5 of em.

 

[RePete]

Can anyone tell me about the SL Variant speed loaders? I just stumbled on 5 of em.

They are good. Some say that they are better than the Comp III's

 

[Moodie]

Too loose.

OP: What revolver do you have?

Can you expand on that? Too loose as meaning the cartridges tend to fall out of the Speedbeez speed loader or what? Thanks

 

[RePete]

Rattle around and they must be inserted at an angle before you drop the shells.

 

[Bushbasher]

Anyone mention the jet loaders
I am a ppc shooter and I run jetloaders and Comp 3s