Hi Everyone,
I just finished putting my Win Mod 70 Classic .300 WSM in a new Boyds salt and pepper laminated stock and I am trying to get it seated a a tight a possible and want to make sure the sequence I am using is the best. Its a 2 piece floor plate with 3 screws. What I have been doing and been told was to tighten the screw on the recoil lug first and as tight as can be then the screw at the back on the tand and the middle screw last and not as tight as the first 2. I have followed this procedure but I am finding that the floor plate does not seat fully in the floor plate release, it only goes in about half way.
any ideas or tipes would be greatly appreciated.
I just finished putting my Win Mod 70 Classic .300 WSM in a new Boyds salt and pepper laminated stock and I am trying to get it seated a a tight a possible and want to make sure the sequence I am using is the best. Its a 2 piece floor plate with 3 screws. What I have been doing and been told was to tighten the screw on the recoil lug first and as tight as can be then the screw at the back on the tand and the middle screw last and not as tight as the first 2. I have followed this procedure but I am finding that the floor plate does not seat fully in the floor plate release, it only goes in about half way.
any ideas or tipes would be greatly appreciated.
