Winclean ammo

[Goglu]

Just purchased a glock 34, I would like to know if annybody had problems with winclean ammo. Heard good and bad about it. Basically I would like to know if its safe for the poly rifling of the Glocks.

Thanks

 

[reddot]

Winchester WinClean is good ammo and perfectly safe for your G34. FWIW it's the preferred ammo for my G17 and G19.

 

[SandRoad]

Winclean is very clean burning, fired cases look almost new.

The bullets are jacketed but the opening in the jacket faces forward, like a hollow-point without the hollow.

I have never had a problem with it in any gun.

 

[Onthebeep]

Bit more muzle flash than comparable loads from Winchester and others but sooooo clean it's unbelievable.

 

[Musky Hunter]

I've put close to 10,000 rds of WInclean in my G17. No problems.

 

[slicknick]

It works great, now go out and shoot some of it

 

[Ruger30-06]

Ive only been using the winclean stuff for my G17.

 

[logik1]

I shoot an HK, but it uses the poly rifling as well, and I've never had a problem with winclean. Only problems with ammo that I've had were with Fiocchi where I was getting split casings. I think there was a recall.

 

[G22]

Only practice ammo I have ever used and zero probs. They all seem to have the flat top.

Never tried the WWB as they call it ('USA Brand' by Le Baron). Not sure which is better, but both are about the same price at Le Baron.

 

[Master-G]

...but sooooo clean it's unbelievable.

Yes, it has to be seen to be believed--the cases looked unfired. I tried a bunch in my USP--seemed about as good as any other Rem or Win factory ammo.

 

[Grove]

I've put close to 10,000 rds of WInclean in my G17. No problems.

+1 for another glock shooter that uses only Winclean. 147gr JHP are.

 

[Chris7_62]

I know of a some users having problems with WinClean .40 eroding the firing pins on their Glocks. Check yours out, YMMV

 

[happiness is a warm gun]

oops

 

[happiness is a warm gun]

It's good ammo. Very.....peppy to say the least. Should bark nicely in a Glock! I can see how your fireing pin would be get eroded from primer contact.

 

[sbe]

your gun will have no problem with it and it is very clean. the only complaint i have is the brass that it leaves in the barrel - the bullet outer shell is brass. I have not found a bore cleaner that handles brass.