UPDATE: FOUND SOLUTION - SEE THREAD ENTITLED:
Wk trigger install problem. Required Pictures are posted here.
Sigh. There is no excuse for this as I had a cell phone, not 2 ft from where I was working.
Went to disassemble the trigger in order to polish up the contact sears in order to remove gritty trigger pull.
Seems like that part of the process was a success.
However, rather than taking pictures of the bolt hold open spring I figured the Wolverine Manual would show a schematic of this.
Apparently, my optimism got the better of me.
I have to head out to pick up my daughter. Thought I'd post this so when I get back I can install the bolt hold open spring correctly.
Can someone post a pic of the top of the lower receiver showing bolt hold open spring installation, please?
Given the safety flops around I figure the spring serves a dual purpose.
Thank you in advance.
L
Wk trigger install problem. Required Pictures are posted here.
Sigh. There is no excuse for this as I had a cell phone, not 2 ft from where I was working.
Went to disassemble the trigger in order to polish up the contact sears in order to remove gritty trigger pull.
Seems like that part of the process was a success.
However, rather than taking pictures of the bolt hold open spring I figured the Wolverine Manual would show a schematic of this.
Apparently, my optimism got the better of me.
I have to head out to pick up my daughter. Thought I'd post this so when I get back I can install the bolt hold open spring correctly.
Can someone post a pic of the top of the lower receiver showing bolt hold open spring installation, please?
Given the safety flops around I figure the spring serves a dual purpose.
Thank you in advance.
L
Last edited:
