WK180C Trigger Upgrade Issue

Y

YKBrute

New member
Rating - 100%
27   0   0
Location
Green Bay South, NL
Hey CGNers. Anyone on here install a Triggertech Adaptive Trigger in their WK180C? I’m having an issue where the top rear of the new trigger group is interfering with the bottom of the bolt catch just under where the pin for the catch goes. It’s just enough interference that I can’t get the bolt catch pin all the way through. I guess the WK accepts MOST AR triggers after all.

Anyone else have a similar issue installing a drop in trigger group?
 
Thanks brother! My plan was to grind a little material off the catch rather than taking the dremel to my expensive trigger pack. Wanted to make sure that taking material off the bottom of the catch wouldn’t cause an issue.

Thanks again for the help!
 
You must log in or register to reply here.
Back
Top Bottom