WSM's powder funnel?

[Oden]

Question for those reloading Winchester Short Mags.
What the heck kinda funnel will fit those bastard fat cases?
Went to load a few rounds for the first time the other night and to my surprize my powder funnels didn't even come close to fitting the case. Ending up using a kitchen funnel with a little duck tape throw into the mix.
Sinclairs have funnels for the WSSM rounds, wonder if those would be compatable? Any thoughts? Cheers!

 

[agilent_one]

I just "softened" a Lee funnel up with a BBQ lighter and pressed it on an empty case. Works well. The funnel is only good for the WSM's now, though.

 

[Scott_N]

I just trimmed a bit off the end / bottom of my RCBS funnel with a utility knife and now it works for my .270 WMS. I had the same problem you did when I loaded my first batch of cartridges.

 

[Lefty Dick]

You can trim your standard funnel to fit, or pick up the MTM set with all the different spouts, the 222 spout works great.

 

[Mighty Peace]

MTM - the company that makes the hard plastic shell cases has a powder funnel kit (red in colour) that fits the WSM calibers. I know that Russel Sports has it listed in their catalouge.

 

[Oden]

Thanks for the ideas guys.
I try the bubba method first, heat and resize, and after I set the funnel on fire, I'll see about the MTM set.

 

[chappy]

the standard rcbs plastic funnel fits fine. i had to buy one when i started reloading short mags. i think it was $7 at my local store

 

[martinbns]

I hacked the bottom off a 260 rem case, put it upside down into the mouth of the funnel.