X95 Micro Tavor Parts Kit

For 2gs you could throw in a non restricted receiver.

Actually, why not just ask IWI for stripped receivers and build them with these parts and sell them.as complete rifles?
 
Not if the stripped receiver was a semi receiver from the factory. You just have to register it after your assemble it. Or keep it NR with a 18.6 barrel.
 
John Rambo said:
For 2gs you could throw in a non restricted receiver.

Actually, why not just ask IWI for stripped receivers and build them with these parts and sell them.as complete rifles?
Click to expand...

Pretty certain IWI is busy supplying their military to even be in a position or interested to provide us with anything currently

gadget
 
Corfius said:
Are all parts compatible with a standard a X95 receiver/stock ? If not which parts wouldn't fit ?
Click to expand...

You might need to take a bit of plastic off the MSW receiver to make one of the control arms function with an aluminum semi receiver insert.

I'm ordering a 13" SBR x95 from IRG as a donor gun to see what else needs to be modified. I'm assuming the full auto trigger pack will stop at the semi insert's "hump" preventing it from fully going in. I'll use the stock semi trigger pack.

There are other minute differences on the x95's that are over 13" from the factory (headspacing, gas) that I have read on other forums. This is most likely from people using the MSW parts in a civi donor x95. I'm going to be doing the opposite.

Technically speaking, you could use all the parts off the MSW parts kit in a donor gun if you have the means. The RC's only prohibbed the serialized MSW receiver and any new receiver should be GTG, giggle bits be damned, as it still won't go brrrpp.

The only "downside" doing this is that from outward appearances, it will look like a prohib MSW when all is said and done. Keep all your provenance with you if you go this route!
 
You must log in or register to reply here.
Back
Top Bottom