Your opinion/experience with E-Lander 10rds pistol mags?

lavino

lavino

CGN frequent flyer
EE Expired
Rating - 100%
2   0   0
Location
Where you can find the most expensive condos...
I ordered 2 x39 pistol 10rds version to play with and I found it fits better on my Scorpio SKS-15. XCR-L mags wobbles a bit too much and cause some FTF. E-Lander mags reduced a lot of the FTF. However, it appears the E-Lander mags is covered in a thick paint which very likely will chip off in a long run. I start noticing the front lip paint is already chipped and exposing the silver meter inside. As new mag they seems to be great but I am not sure they will run just as reliable as the XCR or LAR15 mags. So if you have been using these, do you find that the paint comes off? By the way they seems easier to load 10 rds compare to the XCR mags.
Do they work well in AR15 x39 as well?
 
I think it is a bit depending on the gun and ammo type. LAR15 CPD mags' been very good for all my guns that uses it so I am ok with CPD on the LAR15 I didn't get too good of review on the E-Lander brand generally from my search online but since my XCRs were giving me such a hard time I just ordered 2 to full-fill some free shipping requirement see just "how bad can it be?" Surprisingly it seems to work better than the XCR for my case so far. I still have to wait for SFRC to send me and CFC approval to try out the NEA15 so dunno know if things will be completely diff. As for the Scorpio SKS15 it seems to run better.

So may be case by case for each gun. I am more worry of how they perform in a long run. I personally don't like that thick paint job.
 
You must log in or register to reply here.
Back
Top Bottom