K, bought a TD 9mm with the round hand guard. Love this thing so far! Tight grouping, accuracy is surprisingly great, no fte or ftf. The only problem is I would like to put some picatinny rails on so I can throw on a bipod etc. but not really to sure what's put there for options. Anyone have any ideas. Thanks for the input.
Tacticool Thureon Defence ??
- Thread starter Verno1974
- Start date
You need the octagonal handguard. Don't think there are many options for the round handguard and I know very little about bipods. I have Magpul backup sights, AFG and pistol grip on my TDC. Going to buy a new buttstock soon as well. Here's what they list on their site:
Octagonal Alum. Handguard $69.00
Picatinny Rail Kit (for oct. handguard) $90.00 /set
(includes 2 long and 2 short rails)
I hear their customer service is excellent, feel free to give them a call and see what they say.
Octagonal Alum. Handguard $69.00
Picatinny Rail Kit (for oct. handguard) $90.00 /set
(includes 2 long and 2 short rails)
I hear their customer service is excellent, feel free to give them a call and see what they say.
If this is true, OP contact me as I have a BNIB ODG Magpul MVG you can have for almost nothing. I bought the wrong grip and it's been sitting here in the box.
I can back that. A while ago i had a problem with firing pins breaking. I emailed them and had a response a few hrs later, and my issue was resolved that day. They mailed me a few extra pins that same day. I dealt with Keith Fitch awesome guy and service.
The screw holes at the end of the handguard are about an 1/8 of a turn from being true 180 & 90 degrees. I was kinda hoping to find a slip on picatinny handguard that would mount to the original. But I really don't think there's anything made like that.
I bought a cheap rail section (round handguard guy here) and bolted it to the 11' o clock position to mount a m600c to it.
put a bcm mod 0 grip on it (hate a2's)
for optics i'm running a shield CQS.
FS&G tried to fit a magpul UBR on it, but the treads on the buffer tube are too short to reach the spring retention pin.
I emailed them about getting a manual and the screw pitch for the rails for the handguard, reply in under 10 minutes with all the information I needed.
edit - just saw the post above me.
the diameter of the round handguard is 1.5". some modern 2pc handguards often have the same ID(ar15 has a chart that shows them). With a little modifying, i'm sure you could slide an ar handguard right over the top and bolt it on. I just haven't had the time (or been able to get my hands on a cheap 2pc to clamp over it)
put a bcm mod 0 grip on it (hate a2's)
for optics i'm running a shield CQS.
FS&G tried to fit a magpul UBR on it, but the treads on the buffer tube are too short to reach the spring retention pin.
I emailed them about getting a manual and the screw pitch for the rails for the handguard, reply in under 10 minutes with all the information I needed.
edit - just saw the post above me.
the diameter of the round handguard is 1.5". some modern 2pc handguards often have the same ID(ar15 has a chart that shows them). With a little modifying, i'm sure you could slide an ar handguard right over the top and bolt it on. I just haven't had the time (or been able to get my hands on a cheap 2pc to clamp over it)
