Metro Vancouver - who can drill AR taper pins for Front Sight Block?

[ctcs]

So I know Dlask can do it, but can any one else do in the Lower Mainland?

Virgin barrel, virgin FSB - needs to be aligned, drilled and reamed for #2/0 taper

 

[pbr streetgang]

Give Shane a call at Reliable Gun, you can never miss with that group.

 

[Edzzed]

try Alex.byelan@gmail.com he is a gunsmith in Surrey

 

[Deuce-deuce]

Barry at bits of pieces.

 

[boss351cleveland]

Give Shane a call at Reliable Gun, you can never miss with that group.

Beware , Reliable absolutely butchered my Remington 700 XCR jeweled bolt . Had them put on a extended bolt handle for me and well some idiot clamped it down in a unpadded vice from the looks and the bolt is dented and marred up pretty bad now , and to top it off they tried to hide it with spray paint!!! paint was even still wet when i got it back! lol it was almost comical like it was done in a grade 8 shop class . They never did make it right , should have gave me a new bolt ! bastards . Then the threaded stud they welded on the bolt handle broke off after only a few range trips .NEVER AGAIN!

 

[boss351cleveland]

Barry at bits of pieces.

Barry has done great work for me at a great price , the turnaround time can be slow sometimes but worth the wait to have it done right.

 

[Allstone]

Josef and the guys at Dlask are who I usually bring my stuff to...they're a bit of a drive for me, but better since the perimeter road went in.

 

[sky52]

Barry at bits and pieces also did mine. Afterward tho i was thinking i shouldve gone with an armalite clamp on. That way i can go back to lo pro gas block if i wanted to

 

[sparrow]

Tac Ord is the only place I would send a barrel to have taper pins done. Well worth the cost and time to ship.

 

[8 ball]

Tac Ord did my taper pins for my C8 build for me and I was very happy with the end result!

 

[highspeedlowdrag]

Here's a third for Tac Ord. Had Casey do this for me some years ago and the work was top notch.

hsld.

 

[Paulinski]

Fourth for Casey and Tac Ord.

Casey is an amazin gunsmith and nice guy.

 

[eatredmeat157]

+1 for Dlask. Always great for me.

Tried Gary at bits of pieces. Messed up my 10/22 barrel... Although he did make it right.

Just Dlask for me from now on. Many times they've done great work for me.

 

[ctcs]

Called Dlask, they're too busy to do the FSB install.

 

[erkner]

Dlask his work is superb, timing other think but there is always waiting list for the good ones