looking for someone to cut down a stock and fit a pad

[polskiogorki]

Looking for 1/2 cut off my stock and a pachmyar decelerator ground to fit. Willing to go private or directed to a good smith.
Within a few hrs of gta Ontario.
Thanks!

 

[gwagen]

Why would you willingly install a pachmayr decelerator has to be the worst pad ever made.

If you are in Kawartha lakes, go to Peterborough to Eddie Von Atzingen, but be warned he is busy and if you annoy him you will wait for your job to get done and it will be more expensive.

Does good work though, I haven't used him personally just what I have seen.

 

[polskiogorki]

Why would you willingly install a pachmayr decelerator has to be the worst pad ever made.

If you are in Kawartha lakes, go to Peterborough to Eddie Von Atzingen, but be warned he is busy and if you annoy him you will wait for your job to get done and it will be more expensive.

Does good work though, I haven't used him personally just what I have seen.

Im not stuck on the pachmyar, my citori has one and i like it, but if this gentleman has a better suggestion i would listen.

 

[mwmham]

try Vic Tominson in Waterdown Ont

he's on Trapshooters.com look for username "vdt"



vdt@cogeco.ca

 

[2tall2]

There was another thread recently about converting to an adjustable comb, and Vic was recommended. I believe the OP sent it a couple stocks to Vic and had good results.

 

[JB]

you can call gun works there in warden and steels area or Google them they have a website

 

[Beretta687EELL]

Vic does good work. I've had him do some and so have others that I know. I would have him do work on my guns again.

 

[polskiogorki]

Ended up going to eddie in Peterborough, liked his work on my corwin 14" o/u so much he now has my citori and gold fusion to do a few little things