Gem Pro 250

Scale has been great. Does tend to drift a little bit but not too bad, 0.02 of a grain every 15 minutes or so. Just have to tare it when it does. I usually plug it in at least 1/2 hour prior to using it an have it set on an antistatic pad. As silverfoxdj stated, use it away from other electrical devices. I have also put a magnetic coil interference shield on the power cable.

I have no complaints with the accuracy of scale. It's supposed to be accurate to within 0.02 of a grain if I remember correctly but I've never compared it to a higher end scale.
 
silverfoxdj said:
h ttp://myweigh.com/product/gempro-series/
Click to expand...

This is where I get mine from. They are also excellent to deal with for warranty.
The scale is about the best bang for your buck. It is as accurate as needed for reloading unless you are going to start chopping kernels of powder up to get inbetween the 0.02 grain accuracy.
 
I managed to fry the AC circuits in mine, so I just run it off AAA from work. Also more consistent WRT the calibration weight always reading the same.
I also remove the pan when checking charges from my electronic dispenser, always seems to miss the last couple of kernels when I dump the powder in.
 
Good scale. I've sent a few back with no questions - drift, would not settle on zero. Will do .02 gr....newest one is going strong. Use a Swifter or Balance sheet to rub the pan or cover if it picks up charge.
 
You must log in or register to reply here.
Back
Top Bottom