Walther ppq .22lr 5 inch barrel problems.

M

manley1111

CGN Regular
Rating - 100%
63   0   1
I purchased a new walther ppq .22 and have not been impressed with it. First of all I was getting extraction problems. And then it came 4 inches high and 3 inches left from the factory I had to drift my rear sight way off center and the elevation screw didn't have enough adjustment to bring it down to point of aim. Just wondering if anyone else is experiencing these problems with this new pistol.
 
manley1111 said:
I purchased a new walther ppq .22 and have not been impressed with it. First of all I was getting extraction problems. And then it came 4 inches high and 3 inches left from the factory I had to drift my rear sight way off center and the elevation screw didn't have enough adjustment to bring it down to point of aim. Just wondering if anyone else is experiencing these problems with this new pistol.
Click to expand...

For the extraction problem try different ammo. Worst for me was A&E, the best so far CCI.
Have another shooter try your gun before doing anything to the sights. I I tend to shoot high with it too.
OK
 
Speaking of the rear sight on the ppq, I stripped my windage screw on my m2 .22 the included hex key wasn't an exact fit and was wondering if anyone has any tips on how to get the screw out and secondly where I can get a replacement windage screw for it?

Thanks
 
You must log in or register to reply here.
Back
Top Bottom