Does anyone know what the DA Outlaw is based on ? Thanks
Jamming Outlaw Double Barrel Shotgun
- Thread starter =(M-1)=
- Start date
pavmentsurfer
CGN frequent flyer
- Location
- Minden
Holy Revival Batman
Bobbum Man
Regular
Haha, no kidding.....wonder if it was the ammo after all lol
Does anyone know what the DA Outlaw is based on ? Thanks
shotgun-bob
CGN Regular
- Location
- vancouver island, b.c.
(from my research) the da backpacker was not a copy of a known design...though some features may be copied/used/modified
pretty sure the outlaw falls in the same category...might be loosely based on a certain design
LOTS of old doulble barrels were made (by hand) copying certain features/action/etc (though not exact copies of a design)
i could be wrong, though this is what i've found to be true studying old double barrels
kinda like all bolt actions are based on the needle gun? then so many based on the mauser action, etc
pretty sure the outlaw falls in the same category...might be loosely based on a certain design
LOTS of old doulble barrels were made (by hand) copying certain features/action/etc (though not exact copies of a design)
i could be wrong, though this is what i've found to be true studying old double barrels
kinda like all bolt actions are based on the needle gun? then so many based on the mauser action, etc
thanks for the input.
cndgunguy
Regular
- Location
- National Capital Region
- Location
- B.C
same as mine when it heats up and needs oil
charles u farley
CGN Regular
- Location
- B.C.
Damn, I thought they liked hard insertion. I guess I've been doing it wrong.
Don't even start with the negligent discharges and double barrels...
cndgunguy
Regular
- Location
- National Capital Region
Don't even start with the negligent discharges and double barrels...
At least this post resurrected from the grave is giving us some good puns lol
Anyone else ever notice, less lethal rounds usually look like a French Tickler
it could also be caused by the firing pin(s) sticking in the pin opening.. or defective springs causing them not to extract. The pins stay partially in the dented primer, and by forcing it open you push them back in. This should cause some downward denting of the primer and shell that may give you an indication
krprice84
CGN frequent flyer
- Location
- Calgary, Alberta
just polish up the chamber, and polish up the release mechanism. easy peasy - quick bit of steel wool on a wooden dowel (burr the dowel so it grips the wool better), run it in a drill into and out of the chamber for 2-3 minutes, next chamber, done. a little super fine sandpaper on the release mechanism parts and you should be good to go 
or send it to me and get rid of it - you don't want it anyways. PM me for my shipping address. I can dispose of it properly for you
or send it to me and get rid of it - you don't want it anyways. PM me for my shipping address. I can dispose of it properly for you
krprice84
CGN frequent flyer
- Location
- Calgary, Alberta
and.... I just realized that someone necro'd this post.... damnit. and I got sloppy seconds (or fourths?)
