Sling Plate Adapter

[Donster 125]

Hello everyone,

I am working on my CMMG MK47 build and it is very near completion. Currently, I have a Magpul MOE Fixed Stock with the full extension adapter (the one that sits flush to the receiver plate) as seen here:

I am intersted in obtaining a low-profile QD sling plate that will allow me to use my Magpul MS4 QD sling but ALSO allow me to maintain my flush stock fit that I currently have. I ran across this end plate that seems like it would fit my bill, but I can't seem to identify it. I was wondering if you all could point me in the right direction.

Thanks to all who post!

D

 

[Greenhorse six]

That set up is made by VLTOR I believe , looks like the receiver is machined for the QD sling points.
Troy makes a ambi QD Sling End Plate that might fit your needs , as does Spike IIRC .
Google Ambi QD AR sling plates .

 

[cr5]

You may have trouble using anything like that with a rifle buffer tube and stock. Most of those plates are designed to be used with an M4 4 or 6 position buffer tube with castle nut.
You may end up having to use the QD socket in the back of the stock or doing the old paracord route.
I've never tried using a carbine endplate with a rifle stock but I don't think it will work. Maybe an RSA QD at the back of the top rail would work for your rear attachment point.

 

[mikethebike]

I have one of the vltor stocks, its waiting for an AR to be built.

 

[cr5]

I have one of the vltor stocks, its waiting for an AR to be built.

You can put it on my rifle

 

[Donster 125]

You may have trouble using anything like that with a rifle buffer tube and stock. Most of those plates are designed to be used with an M4 4 or 6 position buffer tube with castle nut.
You may end up having to use the QD socket in the back of the stock or doing the old paracord route.
I've never tried using a carbine endplate with a rifle stock but I don't think it will work. Maybe an RSA QD at the back of the top rail would work for your rear attachment point.

Actually, the Magpul stock pictured goes over a 6 position carbine stock

 

[cr5]

Actually, the Magpul stock pictured goes over a 6 position carbine stock

Oh, they must have 2 versions, I have a magpul stock that looks like that on my TAC-21 chassis, it goes over a rifle buffer.
Looking at that pic it looks like you could use a magpul asap plate, it doesn't have the qd but I use one with my ms3 sling.

 

[K-C]

.

The only item that I can think of that comes close is one of these. I have one fitted to my 858: