Gunsmith to build trapper 1892
- Thread starter joey.45
- Start date
Blastattack
CGN Ultra frequent flyer
- Location
- Winnipeg MB
You can install a new manufactured barrel at any length you wish.
Blastattack
CGN Ultra frequent flyer
- Location
- Winnipeg MB
You can do it yourself if you want. I rebarrelled a prohibited Luger and I sure as heck don't have any fancy licenses.
Who's questioning the answer?? I just stated that the laws about cutting vs new manufacture are a crock of BS. I'll stand by that statement. And I asked for a gunsmith not whether it was legal or not. Read the post.
redshooter
CGN Ultra frequent flyer
- Location
- Central Ontario
Rules are based on ideology not any kind of thoughtful process. This is what you end up with, you want a Trapper, a factory can make it, a new barrel can be added to make it, but no trimming a bit off the end, that would be...well I'm not sure, but bad.
Of course these rules are a crock of crap.
But the fact remains that no gunsmith will brake the law because some one wants them to cut a barrel.
I did read the post.
Cutting a barrel is not manufacting , even if you are licenced.
You can of course install any barrel on a gun that is not too short for that class of gun.
A 4 inch barrel can be replaced with a longer one , no problem, The RCMP will want the 4 in when the gun is registered as restricted.
I get guys want to do all kinds of strange stuff, that would be neat, But I am too old to spend time in court.
But the fact remains that no gunsmith will brake the law because some one wants them to cut a barrel.
I did read the post.
Cutting a barrel is not manufacting , even if you are licenced.
You can of course install any barrel on a gun that is not too short for that class of gun.
A 4 inch barrel can be replaced with a longer one , no problem, The RCMP will want the 4 in when the gun is registered as restricted.
I get guys want to do all kinds of strange stuff, that would be neat, But I am too old to spend time in court.
