Nikko Shadow 707 ejectors extractors

Nikko shotguns were made in the same Japanese factory as the older Winchester 101 that went out of production in the 80's not be be confused with the new 101 made in Belgium. An ejector for an older 101 should fit the Nikko.

I can't recall if these people still ship to Canada but they are the best source for 101 parts.

http://www.midwestgunworks.com/page/mgwi/ctgy/winchester-model-101-factory-parts

If you can't located a 101 ejector I'd suggest trying one from a Browning Citori. The guns are very similar in design and while I haven't tried it personally a Citori ejector might work in one.
 
Numrich Gunparts would be another place to look for the older 101 parts. I believe they have also increased their previous figure of $100 max policy on imports without requisite docs.
 
Claybuster said:
Nikko shotguns were made in the same Japanese factory as the older Winchester 101 that went out of production in the 80's not be be confused with the new 101 made in Belgium. An ejector for an older 101 should fit the Nikko.

I can't recall if these people still ship to Canada but they are the best source for 101 parts.

http://www.midwestgunworks.com/page/mgwi/ctgy/winchester-model-101-factory-parts

If you can't located a 101 ejector I'd suggest trying one from a Browning Citori. The guns are very similar in design and while I haven't tried it personally a Citori ejector might work in one.
Click to expand...

Thanks, I'll give them a call.
 
Nikko shadow ejectors and extractors are not the same as a 101, including the older 101's or Citoris. They are of a completely different design and shape. I have owned all of the above and they are not the same at all.?Your best bet may be Numrich for parts or even Western Gun Parts. Western often can source some real oddballs.
 
the spank said:
Nikko shadow ejectors and extractors are not the same as a 101, including the older 101's or Citoris. They are of a completely different design and shape. I have owned all of the above and they are not the same at all.?Your best bet may be Numrich for parts or even Western Gun Parts. Western often can source some real oddballs.
Click to expand...

Thanks for the info Spank, The Nikko and 101 was made by the same outfit but used different extractors.
 
jpbcal308 said:
Thanks for the info Spank, The Nikko and 101 was made by the same outfit but used different extractors.
Click to expand...

Absolutely correct. The design of the monobloc and extractor system is nowhere near the same. At a glance looking at the outsides of the guns there are some striking resemblances but inside is a different story. The Nikko's and Daiwa's are a nice well built gun though. Needing an extractor after 40-50 years of use is kind of a testament to that fact. I hope you find the parts you need.
 
You must log in or register to reply here.
Back
Top Bottom