How you know it's time to take a break

[dastt]

After doing brass prep on 200 cases including sizing/trimming then loading them this happened on about round 180, figured it was time to take a break before anything serious happened.

I went to re calibrate my scale but forgot to turn off auto dispense so once I hit the zero button without the pan out came the powder, what a mess. The load immediately after I re calibrated the scale I double loaded and ended up spilling more powder.... Ugh time to call it a night

 

[Gun-adian]

Yup, been there.

Time for a nap when that happens......

 

[maynard]

Holy static inside the hopper Batman!

 

[Mr.Crumbz]

Need to stick a dryer sheet in that thing!

 

[hometownhero]

I left the side drain open once and only once. ½ a pound spilt out.

 

[Ganderite]

Murphy strikes again. I have done that and also added powder when the drain was open. More than once...

 

[0neshot]

Holy static inside the hopper Batman!

^ this. And I usually try and keep it to 50 size lots. I do everything the hard way though, a charge master is in the budget for 2017..... If oil and gas can get out of the rut.

 

[turbo_bird]

I left the side drain open once and only once. ½ a pound spilt out.

I've done that too. I wasn't pouring it in slowly either.
Kristian