Bench source Annealer

Remtac

Remtac

Regular
Rating - 100%
14   0   0
Location
Edmonton Alberta
Does anyone have this annealer , you like it ? Just ordered mine it's in the mail on its way , also purchased two hoses and a T joint for the 20lbs propane tank .


 
I have that same annealer. Been awesome - I'm sure you'll be happy with it.

Never thought of running it off a 20 lbs tank though. I've just been using 2 small bottles and haven't even finished those off yet.
 
I had one and loved it. I went with an AMP. Here is a trick with the Bench Source. Download Decibel meter or noise meter on your iphone. Open the app and place your phone under the annealer so you can read the meter. Run the annealer using tempilaq until you get the right timing and heat. When you get it right watch the meter and monitor it during the process. You will duplicate it time after time just by monitoring your decibel meter. If you see the readings go off, it's usually because the gas is getting low.
 
I have the same annealer and it is nice.

I used the primal rights video to set the timing for mine based on the advice from some people on CGN.

I had a couple of pieces of brass that were sacrificed to the Rifle Gods but I thought it was better than tempilaq.
 
jfarrell said:
I had one and loved it. I went with an AMP. Here is a trick with the Bench Source. Download Decibel meter or noise meter on your iphone. Open the app and place your phone under the annealer so you can read the meter. Run the annealer using tempilaq until you get the right timing and heat. When you get it right watch the meter and monitor it during the process. You will duplicate it time after time just by monitoring your decibel meter. If you see the readings go off, it's usually because the gas is getting low.
Click to expand...
That's cool
 
You must log in or register to reply here.
Back
Top Bottom