What would be your best 100yds .308 bullet?

[Kosmic]

If you had a bet with a friend for a 100yds challenge, where would you start for a load development? Or any suggestions. Only 100yds.....I have a few boxes of 178gr Amax but a lighter weight with flat base might be better?

I was thinking 155gr Scenar bullets. (Not flat base though)

My barrel is a Broughton 11 twist 24''

I'm using Varget, Lapua brass and CCI 200 primers.

Thanks

 

[6MT]

....

 

[Chas59]

My best is a Sierra Match King 150gr #2190 projectile, BR2 primer, Lapua brass. Consistently under 1/2 moa for me.

 

[manitou210]

Berger 168 gr Hybrids Varget, Palma lapua brass, FED GM primers .200" at 100

 

[Kosmic]

Berger 168 gr Hybrids Varget, Palma lapua brass, FED GM primers .200" at 100

That's the shooter, not the ingredients

 

[furtaker]

Black hills factory 175 stuff shoots low .100s in a 11.25 twist 308. Get your hands on some of that stuff and save the reloading fir another time.

 

[rifleman338]

I had stellar results with a 168SMK over Varget with a 1-10 twist. Ray Charles could have shot sub MOA with it.

 

[bunny]

In my Ruger 77 International, and my Savage hog hunter the most accurate bullet is the 220 Sierra round nose in front of IMR 4320, not what I would call a classic accuracy load, but both rifles shoot these better than anything else I have tried, going to use this next hunting season.

 

[BioPace]

I had stellar results with a 168SMK over Varget with a 1-10 twist. Ray Charles could have shot sub MOA with it.

This works well for me too.

 

[dan belisle]

The single best target I ever fired at 100 with a 308 was with a 190 gr Speer target bullet. - dan

 

[Robmcleod82]

155 scenars or amax are the bees knees and can be driven fast so they still work well way out there as well.

 

[6MT]

....

 

[308BAR]

155 SMK Palma 2156. Shot one ragged hole for all groups, during 6 different charge weight development at 100m. A good charge of Varget to get it going hard to argue against a flat fast shooting 155.

 

[yodave]

125 grain speer TNT bullets over 48 grains of H4350 with a standard cci large rifle primer...under .2 all day long in a 80's remington BDL varmint rifle....winchester brass and lots of jump as the bullet is seated right at the neck shoulder junction