Strongest 10mm

There are few guns that were designed from the ground up for 10mm. I disagree with pretty much everything said so far. Sure they would last just fine but if you are talking in terms of the absolute strongest designs it's pretty silly to mention guns like the Delta which suffered from cracked frames before it was sent back to the drawing board. Glock 20/40 and SW 1006 are absolute tanks, I find sticky extraction with the 610 long before reaching max in my autos.
 
90% of factory 10mm is weak and downloaded from original spec , dont even worry about wearing out your pistol any time soon , they will all keep going just fine .. I would be thinking more if i want i striker fired pistol like a Glock20 or hammer fired DA like the Sig p220. Some legit loaded 10mm factory ammo 180gr ball is made by HPR , was getting 1260 fps from a G20 . decent priced too from IRG. Also ammo like Underwood and Buffalo bore make legit 10mm too .
 
No question, the superior Glock 20, Glock 20SF is the pistol of choice. Glock polygonal barrels are extremely tough and would stand up to full power loads. All of the other metal guns will experience metal fatigue, cracks, durability issues, and heavily worn bearing surfaces. I'm talking full power loads, all the time.

Tons of quality gun makers like STI make very good 10mm autos that you can weenie out with target, light or medium loads. Plus the Glock is way cheaper though.....
 
There's the whole Reloaders Suck And We Hate You thing with Glock, though

Or is the chamber support on the 40 adequate?
 
You must log in or register to reply here.
Back
Top Bottom