Help Finding Correct Gas Block Pin

A

Anpaul

Regular
Rating - 100%
530   0   0
Location
Edmonton
I'm hoping someone on here might be able to help me track down the correct sized pin for a Daniel Defense gas block. I'm looking for the pin the runs through gas block and secures it to the barrel at the 6 o'clock position in the photo below. If possible, I'd appreciate a link to where I could buy one.

I've checked with a few local shops, but haven't had any luck.

Thanks in advance for your help!

 
You can go to Princess Auto and buy a taper pin kit and just fabricate one. Some of the better stock auto parts store might have them.
 
I've checked with Teir One, as they're local in Edmonton.

I have not checked with Wolverine yet. They deal with DD, so I'll reach out to them
 
I'ts standard industry ( try industrial supply such as Fastenall etc ) American Standard Taper " 2/0 " ...about 3/4 or 5/8 long

It's not some oddball that is unique to gun industry
 
Anpaul said:
Thanks for the feedback. I was able to order in a couple 2/0 - 3/4 from Fastenall. Hopefully they do the trick.
Click to expand...

They didn't make you buy a box of them? Fastenall is a good source for fasteners. A lot of people in the firearms industries order from them. You lose a screw, they just tell you to go to Fastenall and order part#....
 
Nope, surprisingly not. I was able to order just a couple. Total was something like $10 including shipping to their location. They should be here by the end of next week.
 
You must log in or register to reply here.
Back
Top Bottom