Slide Milling in BC

S

sjohnl

Member
Rating - 100%
1   0   0
Hello all,

Could someone point me in the right direction to have slide milling done for a red dot on a glock 19 gen 4. I would probably get the sights switched out as well so it can co-witness. Not certain on which red dot to go with so I wouldn't mind recommendations.

Where would one get this done? preferably local. Your experience? turn around time? price?

TIA
 
I know that Barry Jensen at bitsofpieces.com is in Delta and does a lot of work. Turnaround can sometimes be slow due to volume.

I bought a Glock 17 that had been done by TacOrd in Ontario. They did a great job and installed suppressor sights to co-witness. It was very fast and not too expensive as I only shipped the slide.
 
If you’re getting a Glock done, consult the experts at Black Box Customs.

You might want more than optic cut when you see the work they do.

Alberta, not BC, but still close.
 
You must log in or register to reply here.
Back
Top Bottom