Husqvarna Transformation

[cartridgeguy]

I recently bought an old Husqvarna bolt action single shot in 32-20. It functions great, but it had a previous repair at the wrist that was solid but messy. It also had a chip of wood missing. My wife likes woodworking and she also does checkering, so I gave her this little project. (I do all the metal/steel work - she does the woodwork.) She cleaned the gunk out of the checkering and re-checkered, replaced the missing walnut piece and checkered it.
I think I might have to keep her!

 

[cody c]

Good gravy!

She is good at what she does, two keepers you have there!

 

[cartridgeguy]

Good gravy!

She is good at what she does, two keepers you have there!

Yes to both! Check out the grips she made: https://www.canadiangunnutz.com/forum/showthread.php/19209-1911-s-Pics-Thread/page330
Post is about 2/3 of the way down "TriggerHappyGal"

 

[Hitzy]

Neat and fun little guns to shoot. You will want to relieve the wood around the rear of the tang or it will crack/chip again.
I have one of these, I'll let you guys guess the cartridge.

 

[TriggerHappyGal]

Neat and fun little guns to shoot. You will want to relieve the wood around the rear of the tang or it will crack/chip again.
I have one of these, I'll let you guys guess the cartridge.

Nice little gun!

 

[riversrest]

Neat and fun little guns to shoot. You will want to relieve the wood around the rear of the tang or it will crack/chip again.

This. Relieve the wood a bit...