Glock 19 Canadian and Magpul Magwell problems

Firas

Firas

CGN Regular
Rating - 100%
145   0   0
Location
BC
Just got my Magpull Magwell from CTCS yesterday and after installing it I noticed that my factory glock mags will not seat fully anymore...

It feels like they are pretty close, but I don't want to have to pull out the dremel. Anyone else have this issue? (Yes, the magwell is for the gen 4 g19)
 
I spoke with magpul directly regarding this on my Gen3 G19. The issue is with the baseplates on the glock 10rd magazines, they're slightly thicker than the factory 17rd magazines and they interfere with the magwell. The pinned factory 10/17rd mags and the pinned pmags both work fine.

I did not have this issue with the Gen3 17/34 flared magazine well, factory 10rd mags worked fine.
 
TheReal_Vader said:
I spoke with magpul directly regarding this on my Gen3 G19. The issue is with the baseplates on the glock 10rd magazines, they're slightly thicker than the factory 17rd magazines and they interfere with the magwell. The pinned factory 10/17rd mags and the pinned pmags both work fine.

I did not have this issue with the Gen3 17/34 flared magazine well, factory 10rd mags worked fine.
Click to expand...

Aaah, well it looks like I'll be buying some mag bases or pulling out the dremel if they are too costly.

Thanks everyone for the feedback
 
Firas said:
Aaah, well it looks like I'll be buying some mag bases or pulling out the dremel if they are too costly.

Thanks everyone for the feedback
Click to expand...

You can get replacement baseplaces very inexpensively. If you want some aftermarket basepads, Brownells has a good selection. If you want OEM basepads, I'd check with Sporteque and/or Police Ordnance.
 
I will look into getting replacement OEM ones for now. Going ask to have them measured to make sure haha
 
You must log in or register to reply here.
Back
Top Bottom