BCL 102 after market handguard. What are we using ? Where to get ?
- Thread starter masterduckmaster
- Start date
Midwest industries 12" MI-AR10SSM12 Leaves the adjustable gas block out just enough to adjust itand its almost half the weight of the BCL one...
https://www.midwestindustriesinc.com/product-p/mi-ar10ssm12.htm
Nice pics... I almost want to buy another 102... almost.
Strip receiver set only. That way you can build it using quality parts
I'll wait until the super awesome BCL 102 Wave X receiver sets.
For now, I'm working on another .308 rifle to replace the 102.
Midwest industries 12" MI-AR10SSM12 Leaves the adjustable gas block out just enough to adjust it
https://www.midwestindustriesinc.com/product-p/mi-ar10ssm12.htm
Any gap or difference in rail to receiver height? Midwest told me it's .02 of an inch difference between ar10 and dpms profile. Where did you get it from?
boss351cleveland
CGN frequent flyer
- Location
- Down by the river
Midwest industries 12" MI-AR10SSM12 Leaves the adjustable gas block out just enough to adjust it
https://www.midwestindustriesinc.com/product-p/mi-ar10ssm12.htm
So it looks as the stripped receiver sets have some differences than the ones on the complete rifles? Your upper has a different looking brass deflector , your lower has no ugly flare at the bottom of the mag well too .
- Location
- Richmond, BC
I think Dilli's got a gen 1 lower, hence the lack of a flared magwell.
boss351cleveland
CGN frequent flyer
- Location
- Down by the river
I got a Gen 1 rifle and stripped it for the receiver set
I like the look of your lower better, the flared magwell on mine is uncomfortable has super pointy corners , and its just for show anyway cause on the inside of the well its not really flared at all ? lol its not functional just adds a bit of unwanted meat on the lower !
