Wk180-C technical questions & answers only

Status
Not open for further replies.
Zee705 said:
What's the gas block profile? 0.750" ?
Click to expand...

That is correct.

Bonjour43ma said:
What is the distance from the muzzle to the lower tip of the handguard? I'm guessing 5.7" since the barrel is 18.7" and the handguard is 13"? Thinking to fit a barrel shroud on it.
Click to expand...

vkNcaH7.jpg
 
Zee705 said:
Is Wolverine even monitoring this thread anymore? Seems like there's more than a few questions that have gone unanswered...
Click to expand...

Just an FYI if you go to the first couple posts almost all of these types of questions have been answered.... this thread as well has gone off to more of a general discussion as well, we will not be answering repeat questions.

If we need to we can completely wipe this thread back to the beginning and clean it up.
 
Not sure if this has been answered but how difficult would it be the have a rifle length gas system? Just longer piston?
 
Where and how can I get a manual? Nothing came with my gun,
How can I print off all 3 pages of the FRT? You only have the first page printable.
 
Okay, so the newest production rifles are chambered in 5.56Nato. My rifle arrived a couple of days ago, from Frontier, so I assume it would be part of that latest production. Try as I may, I simply cannot find the chambering marked on it anywhere. Just old eyes? Where the heck is that info on the rifle?

So far (about 200 rounds in...) that is my only "problem". Gas block seems not to be in contact with the handguard, function is close to 100% (1 FTFeed so far).

Of course, the trigger...ah, the trigger...but for the money I didn't expect much in that regard.
 
Last edited:
jjohnwm said:
Okay, so the newest production rifles are chambered in .223Nato. My rifle arrived a couple of days ago, from Frontier, so I assume it would be part of that latest production. Try as I may, I simply cannot find the chambering marked on it anywhere. Just old eyes? Where the heck is that info on the rifle?

So far (about 200 rounds in...) that is my only "problem". Gas block seems not to be in contact with the barrel, function is close to 100% (1 FTFeed so far).

Of course, the trigger...ah, the trigger...but for the money I didn't expect much in that regard.
Click to expand...

.223 Nato? Shouldn't that be 5.56 Nato? Never heard of .223 Nato chambering.
 
.223Nato is a cross between 5.56Nato and .375H&H...5.56Nato casing necked up to .375 caliber. Needs a two piece barrel; the front half unscrews, you drop the shell in and re-attach the front. Lots of knockdown power, but the loading sequence slows down the cyclic rate of fire a tad. :)

Come on...you know what I meant! :) Original post corrected...
 
Status
Not open for further replies.
Back
Top Bottom