Looking for tune up tips to speed up my Dillon 650

[GreenBob]

I can see in the charged cases because I picked up an endoscope with wifi from Amazon and use my cell phone. Just have to finish making the mount for the camera and pick up a clamp for the phone.

Tell me more...what unit and how much was it?

 

[silverfoxdj]

I reload standing and can visually inspect. I have an Inline Fab LED setup and can visually see/check the powder to ensure there's powder and it's not a double charge. Built my bench for my height (5'8") to accommodate the 650 with strong mount.

The FAB lights are a good option I also mount a small mirror to peer right into the case after filling as well

 

[RePete]

Tell me more...what unit and how much was it?

Off Amazon for $18. There is a lag in the picture but not that bad.

You download WiFi Look, turn on the WiFi unit, pair with your phone and then open WiFi Look. It can be a pain at times plus the learning curve.

 

[adamg]

I was thinking about the OP's issue today while reloading on the 650.

OP, are you sure it is the case mouth catching on the resize die? Because it might be the decap pin hitting the base of the case rather than the flash hole.

 

[davide montini]

I wanna sell mine for a mark 7....10 station over a 5 ...at first my press ran super smooth....I bought everything you can buy for it except a auto drive....the problems I have now are weird....my shell plate won’t rotate properly!!...eventually figure it out