Let's See Your WK!!!

Status
Not open for further replies.
Brass Deflector type 2 test:

sgSbYDZ.jpg


:cool:
FDBgJSp.jpg
 
Last edited:
did everyone have to change out the barrel nut to get those handguards on? i'm having a hell of a time trying get the flash hider off.
 
Anonymouse said:
did everyone have to change out the barrel nut to get those handguards on? i'm having a hell of a time trying get the flash hider off.
Click to expand...

Yea, you will need something like Geissele's reaction rod to mount the receiver in a vice. Even the screws on the handguard were tough. Had to be torched to get them off.
 
Drift117 said:
Yea, you will need something like Geissele's reaction rod to mount the receiver in a vice. Even the screws on the handguard were tough. Had to be torched to get them off.
Click to expand...

i tired my hand at the handguard screws. one of them just wouldn't move and i rounded out the hex in it... not having a torch handy i ended up drilling into it with a 3mm bit and then i hammered a square head bit into the hole and put a socket and ratchet on it then it came off. but that screw and the square head bit is permanently fused together now. lol.

The geometry of the upper receiver looks simple enough, i think i'm going to design and 3d print a vice jig to hold my upper in the vice and try it that way. being the cheap guy that i am a $99 tool that i'll use a couple times is not so attractive. but thanks for the info.
 
Anonymouse said:
i tired my hand at the handguard screws. one of them just wouldn't move and i rounded out the hex in it... not having a torch handy i ended up drilling into it with a 3mm bit and then i hammered a square head bit into the hole and put a socket and ratchet on it then it came off. but that screw and the square head bit is permanently fused together now. lol.

The geometry of the upper receiver looks simple enough, i think i'm going to design and 3d print a vice jig to hold my upper in the vice and try it that way. being the cheap guy that i am a $99 tool that i'll use a couple times is not so attractive. but thanks for the info.
Click to expand...

That would be a very useful tool.
 
Watch the port on the gas block when you shoot it with the 15. I'm assuming with the TNA 15"? My left hand got blasted by the gas coming out of the piston system since the TNA rail had more cut outs on it than the factory rail.
 
Drift117 said:
Watch the port on the gas block when you shoot it with the 15. I'm assuming with the TNA 15"? My left hand got blasted by the gas coming out of the piston system since the TNA rail had more cut outs on it than the factory rail.
Click to expand...

i went with one i saw on ebay... probably came from the same place as all those aliexpress ones.
i always shoot with gloves on so i guess i'll be ok.
 
Drift117 said:
Watch the port on the gas block when you shoot it with the 15. I'm assuming with the TNA 15"? My left hand got blasted by the gas coming out of the piston system since the TNA rail had more cut outs on it than the factory rail.
Click to expand...


Ever thought about buying M-LOK rail covers? I have type 1 and 2 covers and type 1 are so soft and comfortable that’s why I like em!
 
Status
Not open for further replies.
Back
Top Bottom